Segway x2 SE - Page 85

Segway Personal Transporter SE Service Manual
C–3
Part Number Fastener Type Application Qty/PT Drive Torque
20540-00005
BHCS, M6 x 1.0 x 20 Console, Front and Rear 3 T-27 11 N-m (8.1 ft-lbf)
20540-00006
BHCS, M6 x 1.0 x 25 Console, Center 1 T-27 11 N-m (8.1 ft-lbf)
20541-00002
SHCS, M4 x 0.7 x 30, SEMS Battery 8 3 mm 1.6 N-m (14 in-lbf)
20553-00001
BHCS, M6 x 1.0 x 25 Gearbox Cover 6 4 mm 6.0 N-m (4.5 ft-lbf)
20553-00002
BHCS, M6 x 1.0 x 28 Fender Frame 6 4 mm 6.0 N-m (4.5 ft-lbf)
20554-00001
SHCS, M5 x 0.8 x 10
Front Console Cover* 2 4 mm 1.5 N-m (13 in-lbf)
Fascia (Front and Rear) 4 4 mm 1.5 N-m (13 in-lbf)
*For use without a Parking Stand.
20554-00004
SHCS, M5 x 0.8 x 20 Front Console Cover* 2 4 mm 1.5 N-m (13 in-lbf)
*For use with a Parking Stand.
20566-00001
PHCS, M3 x 0.5 x 12, SEMS
Balance Sensor Assembly (OEM) 4 T-10 1.6 N-m (14 in-lbf)
Front Light Pipe (OEM) 2 T-10 1.6 N-m (14 in-lbf)
Self-tapping. For use only when installing a BSA into a new Powerbase Chassis,
or when installing a Front Light Pipe into a new Console.
20567-00001
BHCS, M3 x 0.5 x 8
CU Board (OEM) 28 T-10 1.6 N-m (14 in-lbf)
Radio Board (OEM) 6 T-10 1.6 N-m (14 in-lbf)
Power Board (OEM) 8 T-10 1.6 N-m (14 in-lbf)
AC Input Filter (OEM) 5 T-10 1.6 N-m (14 in-lbf)
Self-tapping. For use only when installing a CU Board into a new Powerbase Chassis,
or when installing a Radio Board, Power Board, or AC Input Filter into a new Console.
20871-00001
BHCS, M6 x 1.0 x 18 Fender (x2) 8 4 mm See note.
Tighten one-half to one full turn after fastener is seated.
Fasteners
Table C–1: Fasteners (cont.)