Seko KOMPACT DPT - Alarm and Display Settings; Level Alarm Configuration; Flow Rate Unit Display; Pause Input Setting

EM00136299 rev. 1.0 IT
14
Paragraph 15 – Level Alarm
Programming
Operation
PROG
Config.
+
Alarms
Level
Level
Stop
Level
Alarm
Alarms
Level
Allows you to set the pump for the level alarm activation,
with dosage operation interruption (Stop), or simple
activation of the alarm signal without dosage operation
interruption.
Press
to access the item, then press to set the
alarm type. Press
to confirm. Press to return to
the main menu.
Paragraph 16 – Flow Rate Measurement Unit Display
Programming
Operation
PROG
Config.
+
Unit
Standard
Unit
Standard
Unit
Gph
Unit
ml/m
Unit
L/h
Allows you to set the measurement unit of the displayed
dosage.
Press
to access the item, then press to set the
type of unit, L/h (Liter/hour), Gph (Gallons/hour), mL/m
(milliliters/minute) or standard (% or frequency, according to
the settings). Press
to confirm and return to the main
menu.
Paragraph 17 – Setting the Pause
Programming
Operation
PROG
Config.
+
Paus
N.Open
Paus
N.Closed
Remote input to pause the pump.
By default, the system is set to Normally Open.
Press
to access the item, and then press to set
the value (N. OPEN or N. CLOSED).
Press
to confirm and return to the main menu.