Seko KOMPACT DPT - Batch Dosage with External Impulses; Batch Dosage Configuration

EM00136299 rev. 1.0 IT
7
Display during operation
n:1
P 100%
Function mode
• n:1 (n set)
Alarms and statuses
• Lev = Level Alarm
• Flw = Flow Alarm
•
Value of dosing on going
(depends on unit of measure
selected)
• Percentage, Frequency,
l/h, Gph, ml/m
•
Pump status
• empty = pump in stating
• Stop = pump in stop
• Paus = pump in pause
Paragraph 6 – Proportional to External Impulses (batch dosage)
Programming
Operation
PROG
Config.
+
Config.
Funct.
Funct.
(1:c)
Q.ty
1 ml
Time
10 s
Memory
Off
The pump doses proportionally to an external signal (ex: water meter
pulse-sender). In this case, you can set the quantity to be dosed in
mL and the period of time necessary to complete the dosage.
The dosage can be started manually by pressing
or through a
remote command.
You can press
to interrupt the dosage. The dosage already
made can be reset to zero by pressing
or restarted by pressing
again.
The quantity to be dosed can be modified during operation by
pressing
+ simultaneously to modify the flow rate.
Display during operation
(1:c)
P 100%
Function mode
• Batch
Alarms and statuses
• Lev = Level Alarm
• Flw = Flow Alarm
•
Value of dosing on going
(depends on unit of measure
selected)
• Percentage, Frequency,
l/h, Gph, ml/m
•
Pump status
• empty = pump in stating
• Stop = pump in stop
• Paus = pump in pause
•