-17-
1-2 Aperture Priority mode
1. Hold down the Mode button ⑩ and turn the Jog wheel to
select aperture priority mode
.
2. Turn the Jog wheel ⑤ to set the desired f stop
value.
3. Press the Measuring button ⑭ to take a
measurement.
Release the Measuring button to complete the
measurement. The measured value (shutter
speed) at the time will be displayed.
While pressing the Measuring button, the
meter measures continuously until it is
released.
Reference:
• It is possible to switch between full, 1/2 or 1/3 F stop values with the custom setting mode
(see page 40).
• You can set aperture from 0.5 to F161. Please note that in 1/3 stop increments F0.56 is
displayed as
and F0.63 is displayed as .
• EV scale appears on the analog scale. (Shutter speed scale is not displayed.) For details,
please see page 48.
• After measurement, the shutter speed corresponding to the F stop is displayed when the
F stop is changed with Jog Wheel.
• Readings outside the display range or beyond the measuring range are similar to the
previous instruction (see page 16).
5. Measurement
1/10
shutter
speed
Set f stop value
Measured value
(shutter speed)
Measured shutter speed(blinking)
To Next Page
Loading...
Need help?
General
