-51-
ENGLISH
4) Setting Mid.Tone Value from Memorized Values
After taking three or more reflected Spot measurements, select which memorized value
on the analog scale should be the Mid-Tone value. First enter the memory recall mode
by pressing and holding the MODE button, while pressing the Memory button. Select
one of the memorized values by rotating the Jog wheel and press the MID.TONE button
to set it as the Mid-tone value.
7. Camera Exposure Profiling
NOTE:
• Depending on the lighting conditions, type of photographic equipment and the exposure
standard adopted your exposure result may differ. Please test your setup before shooting
under any conditions.
• It is possible that your set exposure values are not the desired effect for the given
subject matter or shooting situation. Under these situations, please compensate the
values to achieve the desired effect. See section 2-2 "Manual Exposure Profile Input"
(See page 45)
Memory button
Memory recall mode Press MID.TONE to setSelect desired memorized
value as Mid.Tone
To Next Page
Loading...
Need help?
General
