Sekonic SR-3500 - Page 127

-iv-
[Direct under type card (0.25” IBM card size)]
Standard size 187.32
0.2
A
0.2
A
0.2
A
82.55
0.8
6 or more
Minimum 1
5 or more
3.5±0.1
Standard size
General tolerance ±0.2
[Unit: mm]
A
6.35 x 11=69.85
Minimum 1.21
3.5-4.3
6.35
6.35
Cut corner (*)
0.2
A
0.1
* Cut corners and round corners
They help you to easily check if paper is placed in the right direction, and
help you to manage paper and keep it orderly.
Cut paper corners straight or rounded according to the specifications
shown below.
Straight cut corners: standard 6mm or less.
Chamfer angle 45°
Round corners: R 6mm
6mm
45
6mm
(6mm)
R 6mm
(6mm)
Appendix

Sheet creation reference
SR-3565(E).inddSec1:ivSR-3565(E).inddSec1:iv 2007-8-1610:21:382007-8-1610:21:38