Sekonic SR-3500 - Data Reading Settings; Setting Reading Method

-38-
Data reading settings
This section explains how to change various sheet-reading settings.
All settings can also be made using computer commands.

Setting column
Set the column. The number of columns is different depending on the reading sensor.
1.
Press the
MENU
switch to enter the menu mode.
2.
Use the
UP
and
DOWN
switches to select the following parameters,
and press the
FEED/ENTER
switch.
3.
Use the
UP
and
DOWN
switches to select [Setting of Column] setting,
and press the
FEED/ENTER
switch.
(“

” mark fl ashes in the fi rst column of the fi rst line on the LCD.)
4.
Use the
UP
and
DOWN
switches to set the value.
5.
Press the
FEED/ENTER
switch to save the setting value into memory.
(The fl ashing “

” mark disappears from the LCD.)
6.
Keep pressing the
CLEAR/EXIT
switch until it returns to normal mode,
or press the
MENU
switch to return to normal mode.
Column setting values
1 - maximum columns
Sensor pitch Setting range Default value
1/6 inch 1-48 columns 48 columns
0.2 inch 1-40 columns 40 columns
0.25 inch 1-33 columns 33 columns
0.3 inch 1-27 columns 27 columns
Note)
It is necessary to set the number of columns with each operation mode.
Data reading settings

Setting column
SR-3565(E).indd38SR-3565(E).indd38 2007-8-1610:19:252007-8-1610:19:25