Sekonic SR-3500 - Setting Reading Columns

-37-
(4) Use the
UP
and
DOWN
switches to set the value.
2-6.
Setting character code
(1) Press the
MENU
switch to enter the menu mode.
(2) Use the
UP
and
DOWN
switches to select the following parameters,
and press the
FEED/ENTER
switch.
(5) Press the
FEED/ENTER
switch to save the setting value into memory.
(The fl ashing “

” mark disappears from the LCD.)
(6) Keep pressing the
CLEAR/EXIT
switch until it returns to normal mode,
or press the
MENU
switch to return to normal mode.
Flow control
setting values
• RS/CS • Xon/Xoff
• None
(3) Use the
UP
and
DOWN
switches to select [Character Code] setting,
and press the
FEED/ENTER
switch.
(“

” mark fl ashes in the fi rst column of the fi rst line on the LCD.)
(4) Use the
UP
and
DOWN
switches to set the value.
(5) Press the
FEED/ENTER
switch to save the setting value into memory.
(The fl ashing “

” mark disappears from the LCD.)
(6) Keep pressing the
CLEAR/EXIT
switch until it returns to normal mode,
or press the
MENU
switch to return to normal mode.
Character code
setting values
• Accept All
• Ignore 4 Codes
If ignore some is
selected, the following
codes are ignored.
• 20H • 0AH
• 7FH • 1AH
Connecting to a computer

RS-232C
SR-3565(E).indd37SR-3565(E).indd37 2007-8-1610:19:212007-8-1610:19:21