Sekonic SR-3500 - Setting Reading Method

-39-

Setting reading method
Setting mark-reading method.
There are six kinds of reading methods: “Top-end timing control type,” “Bottom-end timing
control type,” “Direct under type,” “FACOM,” “Mark to mark type (without top-end margin
reading),” and “Mark to mark type (with top-end margin reading).”
When setting to “top-end timing control type” or “bottom-end timing control type,” you need
to set a control multiple number.
1. Press the
MENU
switch to enter the menu mode.
2. Use the
UP
and
DOWN
switches to select the following parameters,
and press the
FEED/ENTER
switch.
3. Use the
UP
and
DOWN
switches to select [Reading Method] setting,
and press the
FEED/ENTER
switch.
(“

” mark fl ashes in the fi rst column of the fi rst line on the LCD.)
4. Use the
UP
and
DOWN
switches to set the value.
5. Press the
FEED/ENTER
switch to save the setting value into memory.
(The fl ashing “

” mark disappears from the LCD.)
6. Keep pressing the
CLEAR/EXIT
switch until it returns to normal mode,
or press the
MENU
switch to return to normal mode.
Reading method
setting values
• Control Fore
• Control Back
• Direct
• FACOM
• Mark to Mark
• Mark to Mark

Data reading settings

Setting reading method
SR-3565(E).indd39SR-3565(E).indd39 2007-8-1610:19:282007-8-1610:19:28