Sekonic SR-3500 - Setting Fl Ow Control; Setting Stop Bit

-36-
2-4.
Setting stop bit
(1) Press the
MENU
switch to enter the menu mode.
(2) Use the
UP
and
DOWN
switches to select the following parameters,
and press the
FEED/ENTER
switch.
(3) Use the
UP
and
DOWN
switches to select [Stop Bit] setting,
and press the
FEED/ENTER
switch.
(“

” mark fl ashes in the fi rst column of the fi rst line on the LCD.)
(4) Use the
UP
and
DOWN
switches to set the value.
(5) Press the
FEED/ENTER
switch to save the setting value into memory.
(The fl ashing “

” mark disappears from the LCD.)
(6) Keep pressing the
CLEAR/EXIT
switch until it returns to normal mode,
or press the
MENU
switch to return to normal mode.
Stop bit
setting values
• 1 • 2
2-5.
Setting fl ow control
(1) Press the
MENU
switch to enter the menu mode.
(2) Use the
UP
and
DOWN
switches to select the following parameters,
and press the
FEED/ENTER
switch.
(3) Use the
UP
and
DOWN
switches to select [Flow Control] setting,
and press the
FEED/ENTER
switch.
(“

” mark fl ashes in the fi rst column of the fi rst line on the LCD.)
Connecting to a computer

RS-232C
SR-3565(E).indd36SR-3565(E).indd36 2007-8-1610:19:172007-8-1610:19:17