Sekonic SR-3500 - Buzzer Settings; Buzzer Control

-50-
Buzzer settings
You can set the device to either use the buzzer or not use it.
If you set it to use the buzzer, you can set the volume and tone.
If you set it not to use the buzzer, the buzzer will not sound.

Buzzer control
1.
Press the
MENU
switch to enter the menu mode.
2.
Use the
UP
and
DOWN
switches to select the following parameters,
and press the
FEED/ENTER
switch.
3.
Use the
UP
and
DOWN
switches to select [Buzzer Control] setting,
and press the
FEED/ENTER
switch.
(“

” mark fl ashes in the fi rst column of the fi rst line on the LCD.)
4.
Use the
UP
and
DOWN
switches to set the value.
5.
Press the
FEED/ENTER
switch to save the setting value into memory.
(The fl ashing “

” mark disappears from the LCD.)
6.
Keep pressing the
CLEAR/EXIT
switch until it returns to normal mode,
or press the
MENU
switch to return to normal mode.
Buzzer control
setting values
• Valid
• Invalid
Buzzer settings

Buzzer control
SR-3565(E).indd50SR-3565(E).indd50 2007-8-1610:19:522007-8-1610:19:52