Sekonic SR-3500 - Character Size Setting

-54-

SR-3500,SR-6500 mode
1.
Character size setting
The width of a character can be increased in 0.8mm increments between 3.2mm
and 6.4mm.
(1) Press the
MENU
switch to enter the menu mode.
(2) Use the
UP
and
DOWN
switches to select the following parameters,
and press the
FEED/ENTER
switch.
(3) Use the
UP
and
DOWN
switches to select [Size] setting,
and press the
FEED/ENTER
switch.
(“

” mark fl ashes in the fi rst column of the fi rst line on the LCD.)
No. Size (a)
1 3.2mm
2 4.0mm
3 4.8mm
4 5.6mm
5 6.4mm
a
About 3mm
SR-3500,SR-6500 mode
Character size setting ................................................... P.54
Character interval setting .............................................. P.55
• See P.54 and subsequent pages for SR-3500,SR-6500 mode.
SR-600,SR-9000 mode
Character size setting ................................................... P.57
Character magnifi cation setting .................................... P.58
Character interval setting .............................................. P.59
• See P.57 and subsequent pages for SR-600,SR-9000 mode.
Printer settings

SR-3500,SR-6500 mode
SR-3565(E).indd54SR-3565(E).indd54 2007-8-1610:20:022007-8-1610:20:02