Sekonic SR-3500 - Low Power Consumption Settings; Sleep Duration

-62-
Low power consumption settings
This device can be set to reduce power consumption in standby mode.
The low-power consumption settings make the device automatically reduce power
consumption when it is not used for a certain period.
Sleep mode = low-power consumption condition that it automatically switches to when it is
not used for a set time (sleep duration).
Standby mode = a second low-power consumption condition that it automatically and
continuously switches to after shifting to the sleep mode when it is not used
for a set time (standby duration).
(Power consumption is reduced further than sleep mode.)

Sleep duration
1.
Press the
MENU
switch to enter the menu mode.
2.
Use the
UP
and
DOWN
switches to select the following parameters,
and press the
FEED/ENTER
switch.
3.
Use the
UP
and
DOWN
switches to select [Time for Power Save] setting,
and press the
FEED/ENTER
switch.
(“

” mark fl ashes in the fi rst column of the fi rst line on the LCD.)
4.
Use the
UP
and
DOWN
switches to set the value.
5.
Press the
FEED/ENTER
switch to save the setting value into memory.
(The fl ashing “

” mark disappears from the LCD.)
6.
Keep pressing the
CLEAR/EXIT
switch until it returns to normal mode,
or press the
MENU
switch to return to normal mode.
Time for Power Save
setting values
• None
• 1 - 60 (Minutes)
*Can be set in minute
increments.
Low power consumption settings

Sleep duration
SR-3565(E).indd62SR-3565(E).indd62 2007-8-1610:20:192007-8-1610:20:19