EasyManuals Logo

Selbit ISP - 010 User Manual

Selbit ISP - 010
25 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
www.selbit.pl
- 11 -
Please notice that after setting up the input divider it is needed to
follow next starting instructions otherwise the controller will not
work properly.
2 – Saw trace value checking
To check and eventually change the value of the saw trace please hold for 3 seconds
button with saw symbol. The symbol of the saw trace and its value will be displayed. Now
there is a possibility to check and eventually change this value depends on the saw type used.
Typing in the saw trace please notice that the value is round off to one place after the come.
Example: if you want to type 2 mm first press 2 button and then 0. On the screen 2.0 value
will be displayed. After checking and eventually changing the value of the saw trace to save it
to the controller’s memory pressing “Start/Next Cut” button. Text “Save” should be shown.
3 – Auto-calibration (controller’s checking in with technical parameters of the sawing
frame machine where its mounted)

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Selbit ISP - 010 and is the answer not in the manual?

Selbit ISP - 010 Specifications

General IconGeneral
BrandSelbit
ModelISP - 010
CategoryController
LanguageEnglish

Related product manuals