Selbit ISP - 010 - Head Saw Steering Outputs Connection; Sensor and Magnetic Tape Mounting Example

Fig. 5 Sensor and magnetic tape mounting example
Point – 6
Head saw steering outputs connection
Sawing frame machine where the controller is mounted should be equipped with
head saw up and down feeding contactors ( relays). Contactors steering should be connected
in a such way that it is impossible to work them both in the same time (connecting
contactors cause disconnecting of the other). To create such a way of connection please use
ancillary contactors and connect them according to the diagram below.
www.selbit.pl
- 6 -
Fig. 5 Sensor and magnetic tape mounting example
Head saw steering outputs connection
Sawing frame machine where the controller is mounted should be equipped with
head saw up and down feeding contactors ( relays). Contactors steering should be connected
in a such way that it is impossible to work them both in the same time (connecting
contactors cause disconnecting of the other). To create such a way of connection please use
ancillary contactors and connect them according to the diagram below.
Sawing frame machine where the controller is mounted should be equipped with
head saw up and down feeding contactors ( relays). Contactors steering should be connected
in a such way that it is impossible to work them both in the same time (connecting
of one
contactors cause disconnecting of the other). To create such a way of connection please use