www.selbit.pl
- 20 -
CHAPTER 9
Cutting using program made before (A, B, C)
The controller gives the possibility to create three cutting programs and storage them
into its memory. This option allows for quick call out programs with very often used values
thus shortage of the cutting program.Those programs are named A. B and C.
To use own created program which fulfil your requirements first after holding call out
program needs to be deleted after holding A, B or C buttons.
To delete program first use A, B or C (holding for a while) to call it out. When the number is
displayed, please press and hold “Exit Delete” button and the text “Clr” confirms this
operation and controller goes to normal mode of working.
Creating own cutting program
To create new program in place of the deleted one call it out and after displaying position
number 1 with dashes displayed underneath provide dimensions for 1 to 60. After providing,
save the program pressing “Save Program” button.
If all of the 60 position are not used, the controller automatically overwrite them with last
provided position. Overwriting causes eventually fitting to bigger diameter of the log than
predicted by the operator.
To Next Page
Loading...
Need help?
General
