www.selbit.pl
- 12 -
Please set up manually saw height around 200 mm above the track level and next
press and hold for 3 seconds “Clibr.” button. The text “AutoCall” will displayed and next
please check if is save to start the head saw in automatic movement of auto-calibration. If
starting the head saw is safe and not hurt anyone please press “Calibr. ” button. Controller
make 4 movements of the head saw down and 9 up.
Next, with “End Call” displayed controller will show end of the calibration and break power
do the head saw.
Because of the changes of the sawing frame machine’s mechanical
parameters which depend on variety of factors such as temperature,
frictions factors etc. it is recommended to use auto-calibration at least
twice a week.
4 – real saw height settings
Please check if the mechanical scale (millimeter scaled strip with saw height indicate
needle) is scaled correctly, thus shows real head saw height above the main track of the
machine. It will help with checking rest of the parameters later on.
Correct height indicator is important for correct controller’s calibration.
When the indicator is scaled correctly please set up manually full millimeter value of
the head saw, read it correctly and save it into controller’s memory as follow:
Press and hold “Set Height” button for 3 seconds and on the upper display dashes will
be displayed. Next please type in the read actual saw height value using numeric keyboard.
Please type the value briskly because with longer pause controller end this operation. If there
To Next Page
Loading...
Need help?
General
