33
4.0 POSSIBLE PROBLEMS
The problems that arise in welding can have electrical or mecha-
nical origins or can be due to an incorrect use of the apparatus.
The problems relating to welding are described in the operato-
r's manual the generator.
WF 110 / WF 111
5.0 ACCESSORY KIT WF 110 / 111
COMPOSITION CODE
Accessory kit for wirefeeder 2 rollers
for solid and cored filler wire 73.10.056
Lower roller for wire-tightner for solid wire, Ø 0.8-1.0 mm
Lower roller for wire-tightner for solid wire, Ø 1.2-1.6 mm
Lower roller for wire-tightner for flux core wire Ø 1.2-1.6 mm
Silicone-free non stick spray
Accessory kit for wirefeeder 2 rollers for aluminium 73.10.057
Lower roller for wire-tightner for aluminium, Ø 1.0-1.2 mm
Lower roller for wire-tightner for aluminium, Ø 1.2-1.6 mm
FAULTS
The wire does not feed
The wire feeds but the arc
does not strike
CAUSA
a) line fuse blown.
b) switch off.
c) fuse on generator blown,
d) torch switch faulty.
e) cable bundle defective.
f) rollers worn.
g) torch nozzle melted (wire
stuck).
h) generator alarm triggered.
i) soft start on and value set to
minimum.
l) door open
a) earth return clamp is not
making contact with the
piece to be welded.
b) incorrect selection and set
up of welding parameters.
c) positive cable (cable undle)
disconnected.
d) fault in generator (contact
the SELCO Service Dept ).
To Next Page
Loading...