SELFSAT SNIPE PRO - Update Process

12
4-2. Update Process
i.
①
Download the SNIPE PRO Update
Program to your PC from our
website (www.selfsat.com).
②
Download the newest satellite data to
your PC from our website .
③
Connect the controller to your PC using USB cable, then install the SNIPE PRO Update Program
you downloaded.
※
Download driver le, if your OS does not
support it.
※
Be sure your product location and download
correct location le.
Using SNIPE PRO Update Program, refresh the satellite data of your SNIPE PRO.
Update Program download
ii. Update the 10 satellites which are pre-stored
④
⑤
⑥
Run the SNIPE PRO update program.
Click “le” on left-upper side on program,
and click "open" to select folder which
contains downloaded satellite data.
Select folder and click the “OK” button.
⑦
When folder is opened, select le and
click the “Open” button.
⑧
⑨
The data of 10 satellites are shown to
you, but they are not modiable by
yourself.
Check the Port Setting, then click the
“CONNECT” button.