English
23
Each project with constant temperature controller needs to base exclusively
on customer design and calculations and needs to be in compliance with
valid rules and regulations. Pictures, diagrams and text in this manual are
intended solely as an example and the manufacturer does not accept any
responsibility for them. If you use content of this manual as a base for your
project, then you carry also full responsibility for it. Responsibility of publisher
for unprofessional, wrong and false information and consecutive damage are
explicitly excluded. We retain the right for technical errors, mistakes, changes
and corrections without prior notice.
Installation of controlling devices should be done by an expert with suitable qualications
or by an authorised organisation. Before you deal with the main wiring, make sure that the
main switch is switched o.
You have to follow the rules for low-voltage installations IEC 60364 and VDE 0100, law
prescriptions for prevention of accidents, law prescriptions for environmental protection and
other national regulations.
CONTROLLER’S ELECTRIC CONNECTION
CONTROLLER INSTALLATION
Install the regulator inside in a dry place, where it is not exposed to any strong electromag-
netic elds.
INSTALLATION MANUAL
To Next Page
Loading...