32
Technical data/General declaration of conformity
6. Technical data
Series Torque
Nm
Rotation speed
Rpm
Power Input
A
Output
W
1/6 6 15 0.50 115
1/10 10 15 0.50 115
2/6 6 28 0.45 105
2/7 7 17 0.41 95
2/9 9 28 0.66 152
2/10 10 17 0.55 124
2/12 12 28 0.75 172
2/15 15 17 1.66 152
2/18 18 28 1.95 220
2/20 20 17 0.75 172
2/30 30 17 0.95 220
2/40 40 17 1.50 345
2/50 50 12 1.50 345
3/50 50 17 1.40 315
3/60 60 12 1.10 245
3/70 70 17 1.90 435
3/80 80 12 1.40 322
3/120 120 11 1.90 435
Installation location:
After installing the drive, mark the drive type in the technical data table and make a note of
the installation location.
Series 2 motors have a plug-in connection cable. Series 1 and series 3 motors have a 2.5 m
mains cable as standard which is permanently installed and cannot be replaced.
The relevant cable lengths and qualities for series 1, series 2 and series 3 can be selected in
the catalogue.
Connection cables must be ordered separately.
Information about connections using special connectors must be requested.
Information for all motor types:
Nominal voltage: 230 V AC/50 Hz
Safety class: IP 44
Subject to change without prior notice!
7. General declaration of conformity
SELVE GmbH & CO. KG company, hereby declares that the SE Plus is in con formity with the
basic requirements and other relevant provisions of the Directive 2006/42/EG, 2014/53/EU,
2014/30/EU and 2011/65/EU. The declaration of conformity can be looked up at
www.selve.de
To Next Page
Loading...
