Sena 10Upad - 14 CONFIGURATION SETTING; Entering and Navigating Configuration

10Upad
40
14 CONFIGURATION SETTING
You can set the conguration of the 10Upad by the voice menu
instruction described below.
1. To enter into voice conguration menu, press and hold the Center
Button for 10 seconds until the LED shows solid blue and you
hear high toned double beeps. You will also hear a voice prompt,
“Conguration menu”.
2. Tap the (+) Button or the (-) Button to navigate between the
menus. You will hear voice prompts for each menu item as below.
3. You can enable/disable a feature or execute a command by
tapping the Center Button.
4. If no button is pressed within 10 seconds, the 10Upad will exit the
conguration and go back to stand-by mode.
5. If you want to exit the conguration immediately, tap the (+)
Button or the (-) Button until you hear a voice prompt, “Exit
conguration”, and tap the Center Button.
The voice prompt for each menu item is as below:
(1) Phone pairing (10) Voice prompt
(2) Second mobile phone pairing (11) RDS AF setting
(3) Phone selective pairing (12) FM Station Guide
(4) Media selective pairing (13) Noise control
(5) Speed dial (14) Delete all pairings
(6) Audio Boost (15) Remote control pairing
(7) VOX phone (16) Universal intercom pairing
(8) VOX intercom (17) Factory reset
(9) HD intercom (18) Exit conguration