Sena 10Upad - Selective Pairing and Speed Dial

10Upad
42
14.3 Phone selective pairing
Voice Prompt
“Phone selective pairing”
Factory Default N/A
To go into phone selective pairing mode, tap the (+) Button or the (-)
Button until you hear the voice prompt, “Phone selective pairing”.
Please refer to section 5.3.2, “HFP for Phone Call Only” for details on
phone selective pairing. If you tap the (+) Button or the (-) Button, you
can exit from the phone selective pairing mode.
14.4 Media Selective Pairing
Voice Prompt
“Media selective pairing”
Factory Default N/A
To go into media selective pairing mode, tap the (+) Button or the (-)
Button until you hear the voice prompt, “Media selective pairing”.
Please refer section 5.3.1, “A2DP Stereo Music Only” for details on
media selective pairing. If you tap the (+) Button or the (-) Button, you
can exit from the media selective pairing mode.
14.5 Assigning Speed Dial
Voice Prompt
“Speed dial”
Factory Default N/A
Execute Tap the Center Button
1. To assign a phone number as a speed dial, tap the (+) Button or
the (-) Button until you hear a voice prompt, “Speed dial”.
2. Tap the Center Button, and you will hear a voice prompt, “Speed
dial one” and “Phone connected”.
3. Tap the (+) Button or the (-) Button to select one of three speed
dial numbers and you hear a voice prompt, “Speed dial (#)”.
4. Call a phone number you want to assign and you will hear a
voice prompt, “Save speed dial (#)”. The phone number is
automatically assigned to the selected speed dial number. Then
the phone call will hang up before being connected.
5. To exit the menu, tap the (+) Button or the (-) Button until you
hear a voice prompt, “Cancel”, and tap the Center Button to
conrm. You will then hear a voice prompt, “Cancel”. If no button
is pressed within 1 minute, the 10Upad will exit the conguration
menu and go back to stand-by mode.