10Upad
49
16 FIRMWARE UPGRADE
The 10Upad supports rmware upgrades. You can update the rmware
using the Sena Device Manager (please refer to
section 4.6.1, “Sena
Device Manager”
).
17 TROUBLESHOOTING
17.1 Intercom Failure
When you try to start an intercom conversation with an intercom friend
who is unavailable within range or already having a conference
intercom with other riders or a mobile phone call, you will hear a low
tone double beep signifying an intercom busy signal. In this case, you
have to try again later.
17.2 Intercom Reconnection
If your intercom friend goes out of range while having an intercom
conversation, you may hear static noise and eventually the intercom
will be disconnected. In this case, the 10Upad automatically tries to
reconnect the intercom every 8 seconds and you will hear high tone
double beeps until the intercom is reestablished. If you do not want to
make a reconnection, tap the Center Button to stop the attempt.
To Next Page
Loading...
