Sena SRL-EXT User Manual

SRL-EXT Motorcycle Mesh & Bluetooth
®
Communication System for Shoei Helmets | 15
2 INSTALLING THE HEADSET ON YOUR HELMET
8. Clean the area on the right side of your helmet where you will attach
the double sided adhesive tapes with moistened towel and dry
thoroughly.
9. Peel off the double sided adhesive tapes to the back of the battery.
10. Place the battery cable so that it meets the end of the lettering as
shown in the illustration. Then, attach the battery to the right side of
the helmet with double-sided adhesive tape.
Meet each other
Note: Make sure that the main unit is firmly attached to the helmet.
Maximum adhesion occurs after 24 hours.
11. Align the battery cable with the concave portion on the inner
padding of the helmet. Then, attach the battery cable to the inside
of the helmet with adhesive tape.
2
1
Concave
Portion

Sena SRL-EXT Specifications

General

Audio Advanced Noise Control	Yes
Audio Built-in SBC Codec	Yes
Audio Wide Volume Control	Yes
Battery Charging Time	2.5 hours
Certificates	CE, FCC, IC
Music Sharing	Yes
FM Radio	Yes
Voice Command	Yes
Operating Temperature	-10°C to 55°C
Profiles	HFP, HSP, A2DP, AVRCP