SRL-EXT Motorcycle Mesh & Bluetooth
®
Communication System for Shoei Helmets
| 11
2 INSTALLING THE HEADSET ON YOUR HELMET
2.1.2 Preparing the Headset for Installation
Speaker (R)Speaker (L)
1. Align the arrows on the main unit’s microphone connector cable
and microphone cables, and insert the microphone cable into the
microphone connector.
2. Align the arrows on the main unit’s speaker connector cables and
speaker cables, and insert the speaker cables into each speaker
connector.
3. Align the arrows on the main unit’s battery connector cables
and battery cables, and insert the battery cables into each battery
connector.
2.1.3 Installing the Headset
1. Place the clamp guide sheet on the border between the outer shell
and the inner padding on the left side of the helmet, and position it
at the end of the lettering.
EMERGENCY USE ONLY
PULL RED TAB AND REMOVE CHEEK PAD
Clamp Guide Sheet
Note: The clamp guide sheet’s arrow should be pointing toward the
end of the lettering.
To Next Page
Loading...
Need help?
General
