Putting the AMBEO Soundbar into operation
AMBEO Soundbar | 29
Calibrating the Soundbar
▷ Straighten up the microphone in the microphone holder.
▷ Place the microphone with the microphone holder on the seat in
front of the Soundbar. The microphone head should be located
approximately at ear height during normal use.
▷ Connect the jack plug of the microphone cable to the microphone
input on the Soundbar.
▷ Press the AMBEO button on the top of the Soundbar or the
AMBEO button on the remote control.
The display shows “Please step to the side”.
Please note that the test tones are played at a high volume during
calibration.
▷ Avoid disturbing noises (open windows, household appliances,
etc.) and do not stay between the Soundbar and the microphone
as this can falsify the calibration.
The display shows a countdown for the start of the calibration
“Ca
libration starts in 10 / 9 / ...”.
The calibration process takes several minutes.
The display shows “Done!” and “Press AMBEO to finalize”.
▷ Press the AMBEO button on the top of the Soundbar or the
AMBEO button on the remote control.
The display shows “Welcome”. The AMBE
O demo sound is played
(approx. 10 seconds).
▷ Disconnect the jack plug of the microphone cable from the micro-
phone input on the Soundbar.
To Next Page
Loading...
