accuMAG Meter Quick Guide Software v4.1.2 WQG-10004-01
3 Electrical Connections
3.1 Safety Instructions
All work on the electrical connections may only be carried out with the power disconnected. Take
note of the voltage data on the nameplate!
Observe the national regulations for electrical installations!
Observe without fail the local occupational health and safety regulations. Any work done on the
electrical components of the measuring device may only be carried out by properly trained
specialists.
Look at the device nameplate to ensure that the device is delivered according to your order. Check for
the correct supply voltage printed on the nameplate.
| sales@mvandc.com | Phone: 877.566.3837 | Fax: 925.407.2903
To Next Page
Loading...
