SENTINEL
PROPRIETARY INFORMATION AND MATERIALS OF UNITEC INC. 86
The number of rejects depends directly on the loading procedure and the quality of the bills. Without
preparation, feeding problems may occur, such as higher reject rate or jam in the transport path. The
following procedures are recommended to aid easier bill feeding from cassettes.
If you are using new, unused bills:
• Remove the band around each bundle of bills.
• Separate the bills from each other by:
o Striking the bundle hard against the edge of a table or similar object.
o Flipping through each bundle of bills in both directions at both ends.
If you are using used bills:
• The bills must not be limp and should be reasonably clean.
• Remove the band around each bundle of bills.
• Remove foreign objects, e.g., pins, paper clips, crumbs etc.
• Remove torn or very worn bills.
• Straighten any folded bills.
Do not use the following types of bills:
• Sticky surfaces
• Repaired with tape
• Torn edges
• Having holes or missing sections
• Crumpled
• Dog-eared, with a folded edge exceeding 5 mm
• Limp or moist
• Combination of new and used bills in the same cassette
To Next Page
Loading...
Need help?
General