Section 4 Maintenance
Part Number 020003996 4/12 4-5
QUICKDRAW COMPONENTS
1. Turn the beverage valve switch on the front left side
to the off position.
2. Place a receptacle (bucket or large cup) under the
ice dispense chute.
3. Place the ice dispense switch to MANUAL mode.
The door will open and ice will fall into the bucket
or cup.
4. Remove the ice chute cover:
A. Grab the tabs on the back of chute and spread,
pulling tabs off of pins.
B. Push the bottom of chute to rear until it stops.
C. Rock top of the chute forward until top of chute
clears unit.
5. Mix a solution of mild detergent to clean the
quickdraw components. Using the detergent solution
and a soft bristle brush or clean cloth, clean the
following components:
• Cup locator
• quickdraw chamber
• Door
• Ice chute cover
6. Rinse all parts in clean running water.
7. Mix a sanitizing solution of 1/4 ounce liquid,
unscented bleach (5.25% CL NaO concentration) for
each gallon of water. The mixture must provide 100-
PPM available chlorine.
8. Using the sanitizing solution, a soft bristle brush, or
a clean cloth, sanitize the components listed in Step
Beverage Valve
Switch
Ice Dispense Switch
To Next Page
Loading...
