Sesamo smart PRO - Parameter List - Part 4 and Status Signals

59
SESAMO SMARTPRO
42
Polarity test sensor
0 = NA (Normally Open)
1 = NC (Normally Close)
1
43
Not Used
-
-
Sd
Set to default
1-Select Sd pushing buttons [+] e [-]
2-Push [ENT]
3-when displays [--] push again[ENT] for 5 seconds to confirm
4-when disappears [--] leave the push button [ENT].
-
Lp
Learning cycle
1- Select Lp pushing buttons [+] e [-]
2-Push [ENT]
3- when displays [--] push again[ENT] for 5 seconds to confirm
4- when disappears [--] leave the push button [ENT]. Lp
starts, see Start Up.
-
In
Information
0-firmware version of the user controller e.g. 1:04
1- firmware version of the safety controller e.g. 1:02
2-type of automatism (C0= Smart Pro)
3-Door weight (see parameter nr 31)
4- total number of operations performed by the control unit.
5- sensor configuration (see parameter 18)
-
24.SEGNALAZIONI DI STATO
SEGNALAZIONE
DESCRIZIONE
OP fisso
Door in open position
OP Lampeggiante
Door opening
CL Fisso
Door in closed position
CL Lampeggiante
Door closing
St
Door stop