Sesamo smart PRO - 25. Error Messages and Diagnostics

60
SESAMO SMARTPRO
25.ERROR MESSAGES
INDICATION
DESCRIPTION
E1
Waiting for initialization (Learning procedure LP)
E5
Missing Main-Key
E6
Error configuration monitoring sensors
(Necessary to set parameter 18)
E7-5
Overcurrent
E7-6
Time-out Movement (greater than 60”)
E7-A
Supply voltage overload, out of tolerance
E8-1
Error Test connection Motor and Encoder
(Verify the connection between Motor and Encoder).
E8-8
Error Diagnostic Encoder
E8-A
Switching power overload
E9
Activation safety function
N.B.:
following errors:
E3 / E4 / E7-2 / E7-3 / E7-4 / E7-7 / E7-8 / E7-9 / E7-b / E7-C / E7 -F / E8-2 / E8-3 / E8-4 / E8-5 /
E8-6 / E8-7 / E8-9 / E8-b.
They are related to transient anomalies. If they persist, replace the board and send it to Sesamo with the
indication of the error code reported.