SEW-Eurodrive ECDriveS ECC-DFC - Left and Right Sensor Connections

Hardware connections
Manual – ECC-DFC field bus controller
19
4.2. Left and right sensor connections
Figure 4 Sensor connector
Each sensor connection is a standard M8 socket with the following pin assign-
ment:
Figure 5 Sensor connection
Pin
Signal
Description
1
DC 24 V
DC 24 V module supply
2
Aux I/O
I/O signal – function can be configured with the ECShell engineering software
3
GND
DC supply ground of the module
4
Sensor signal
Logical input for the status output of the sensor – automatic detection of NPN or PNP