SEW-Eurodrive ECDriveS ECC-DFC - Power Connections

Hardware connections
22
Manual – ECC-DFC field bus controller
4.4. Power connections
4.4.1. IP54 installation
Parts [12] and [17] as shown in figure 2 are not connected to the module when it
is delivered but are supplied separately in the module box. These parts are
needed in order to create a power wiring installation that is compliant with IP54.
The power cables are routed through the cable gland [17]. The cable terminals
are standard spring terminals.
When the wiring is complete, the power wiring compartment is securely closed off
with a cover [12].