ECShell engineering software
Manual – ECC-DFC field bus controller
INFORMATION
The subnetwork concerned will no longer work from this point in time, since the
IP address of its auto configuration master has been changed. You must now
perform the auto configuration procedure again so that the IP addresses of all
downstream modules are updated in order to match the address of the auto con-
figuration master subnetwork.
8.3. ECShell main window
Once you have changed the configuration of the PC or that of the auto configura-
tion master as described, you are able to use the ECShell main window. You can
have the status of the system displayed and modify parameters here. If you pro-
ceed as shown in the example above, the main window is displayed when you
close the advanced dialog.
The main window is also displayed when you start ECShell for the first time.
Figure 30 ECShell main window
Network IP – This is where you enter the subnetwork of the network to
To Next Page
Loading...
