ECShell engineering software
Manual – ECC-DFC field bus controller
8.2.2. Method 2 – Modifying the PC to adapt to the auto configuration master
Since you now know the IP address of the auto configuration master, you can
simply change the IP address configuration of the PC at this point so that it has
access to the subnetwork of the auto configuration master. In the example shown
above, the IP address of the auto configuration master is 10.10.10.20, according
to which the subnetwork is 10.10.10.
8.2.3. Method 3 – Modifying the IP address of the auto configuration master
If you would like to modify the preset IP address of the auto configuration master
that was used when the auto configuration procedure was carried out, you can do
this in the network service window.
Double-click the auto configuration master in the list. This results in its IP address
information being filled in, as shown in the following figure. Now enter the new IP
address information that you would like to use and click “Set”.
If you click “Discover” again after clicking “Set”, ECShell updates the module list
on the left-hand side. You can now check whether the new settings of the IP ad-
dress have been copied for the module.
To Next Page
Loading...
