Hardware connections
Manual ā ECC-DFC field bus controller
In order to correctly fit the IP54 protective sleeve to the RJ45 connector, a special
tool is required. Figure 9 shows a Phoenix Contact 2891547 FL IP 54 assembly
tool.
INFORMATION
This tool is not included in the scope of delivery!
Figure 9 shows a Phoenix Contact Ethernet switch 2891547 FL IP 54 assembly tool
NOTICE!
It is advisable for all Ethernet cables between the modules to be shielded. The
use of unshielded cables can lead to loss of data and unexpected results.
To Next Page
Loading...
