Auto configuration of the linear conveyor
Manual ā ECC-DFC field bus controller
The node selected for auto configuration does not have to be the first module that
is directly connected to the PC. The module at the other end of the line can also
be selected as the auto configuration master, as shown in figure 22.
Figure 22 Auto configuration from the node furthest away from the PC
7.5.1. Automatic detection of the position of the module at the opposite side
The cable connections between the left and right Ethernet connection can be
used if the module is going to be installed at the opposite side frame of the con-
veyor system. When it is correctly connected, it is detected by the auto configura-
tion program, and the flow rate is configured accordingly.
Figure 23 shows an example of the detection of the opposite position.
Figure 23 Example of a module positioned at the opposite side
To Next Page
Loading...
