Table of Contents
Produkthandbuch – ECC-DFC field bus controller
4.4. Power connections ................................................................................................. 22
5. Connections for linear conveyors .................................................................................... 25
5.1. Example 1 – Two-zone controller ........................................................................... 25
5.2. Example 2 – Single-zone controller ........................................................................ 26
5.3. Example 3 – Double-motor-roller, single-zone control ............................................ 26
5.4. Examples of invalid configuration ........................................................................... 26
5.5. Definition of motor direction of rotation ................................................................... 27
6. Status displays .................................................................................................................. 28
6.1. Communication ...................................................................................................... 28
6.2. Network and module function ................................................................................. 28
6.3. Motors .................................................................................................................... 29
6.4. Sensors .................................................................................................................. 29
6.5. Power ..................................................................................................................... 29
7. Auto configuration of the linear conveyor ....................................................................... 30
7.1. Definition of a linear conveyor ................................................................................ 30
7.2. Installation of the ECShell engineering software ..................................................... 30
7.3. Definition of the ECC-DFC Ethernet ....................................................................... 31
7.4. Connect PC to the fieldbus controller network ........................................................ 33
7.5. Auto configuration procedure ................................................................................. 33
7.6. Results of auto configuration .................................................................................. 37
7.7. Jam statuses .......................................................................................................... 41
7.8. Network error ......................................................................................................... 42
7.9. Low voltage fault .................................................................................................... 42
7.10. Automatic module replacement .............................................................................. 42
7.11. Module replacement ............................................................................................... 43
8. ECShell engineering software........................................................................................... 45
8.1. Introduction ............................................................................................................ 45
8.2. Options for configuring the IP address of a PC ....................................................... 46
8.3. ECShell main window............................................................................................. 53
8.4. Establishing a connection with the ECC-DFC fieldbus controller ............................ 54
8.5. Advanced dialog ..................................................................................................... 68
To Next Page
Loading...
