ECShell engineering software
Manual – ECC-DFC field bus controller
Figure 31 Example of a module diagnosis window
Sensor status – OFF means sensor is clear; ON means sensor is blocked
Status of local upstream/downstream zone
Status of zone upstream of module – “-“ means that no connection is config-
ured
Status of zone downstream of module
Current status of connected motor – the current strength, motor type, and
direction of rotation are displayed. Note that a red “!” means that no motor
current is present at the module
No motor connection – in this example the module is configured so that it
has 2 zones and 2 motors, but the connection to the motor of the down-
stream zone has been interrupted, which is indicated by a red “X”
To Next Page
Loading...
