ECShell engineering software
Manual – ECC-DFC field bus controller
NOTICE!
Some aspects of material transport, such as the speed of the discharge convey-
or and the weight of the load, must be carefully analyzed before using a T-bone
configuration.
Be sure to check the mechanical design and the load characteristics before start-
ing up a T-bone arrangement.
Connecting modules of a fieldbus controller for a T-bone arrangement
A T-bone arrangement can be started up in one of the following ways:
Sending and accepting zones are on the same module
Sending and accepting zones are on different modules
Figure 35 and figure 36 show the two ways of connecting the motor rollers and
photo sensors to the modules of the fieldbus controller for obtaining a correct T-
bone configuration.
Figure 35 Single ECC-DFC T-bone example
To Next Page
Loading...
