ECShell engineering software
Manual – ECC-DFC field bus controller
For example, the motor roller information in figure 32 shows that the nominal
speed of the motor roller that is connected to the module is 60 m/min or 1 m/s.
Entering a value of “1” for the speed and clicking “Set” sets the speed of the roll-
er. If the background of the speed entry field remains white, it is a permissible
speed value.
For our example roller, a speed of 2 m/s is above the maximum permissible
speed. The background of the input field turns red and therefore indicates
that the entered speed is too high.
For our example roller, a speed of 0.1 m/s is below the permissible minimum
speed. The background of the input field turns blue and therefore indicates
that the entered speed is too low.
To Next Page
Loading...
