ECShell engineering software
Manual – ECC-DFC field bus controller
Clicking the “Set” buttons for the Jam timer or the Run After timer results in the
entered setting being downloaded to the respective zone of the selected node.
Detailed information about the settings and functions of the Jam timer and the
Auto Clear timer can be found in the pop-up window of the ECShell engineering
software.
Clicking “Set All” for the Jam timer or the Run After timer results in the entered
values being used on all nodes of the range defined in the main window. Detailed
information about the settings and functions of the Jam timer and the Auto Clear
timer can be found in the ECShell engineering software.
To Next Page
Loading...
