SEW-Eurodrive PZM2xA-A075-D02-00 - Page 17

2
Interface box
Electrical installation
Addendum to the Operating Instructions – MOVIPRO
®
– Accessories
17
2.8.5 DC 24 V supply
The MOVIPRO
®
is equipped with a DC 24 V output that can be used to supply the
MOVIPRO
®
from the DC link.
To use the DC24V supply from the DC link, you must jumper the following terminals
in the interface box:
• 1 with 3
• 2 with 4
The following figure shows the wiring for using the DC24V supply from the DC link:
1 2 3
4
18014400675416459
INFORMATION
If you use an external DC 24V backup voltage, do not connect terminals 1 and 2.
To use an external DC24V backup voltage, connect it to the following terminals:
• 3
• 4
The following figure shows the wiring for using an external DC24V supply:
1 2 3
4
18014400675412875
23106913/EN – 02/2018