SUMMARY
1 . INTRODUCTION p2 5 . DIRECT FUNCTIONS p22
2 . DIMENSIONS p5 5.1 Zero reset of the Min / Max. values p22
3 . CONNECTINGS p6 5.2 Display of the direct input measure p22
4 . PROGRAMMING p7 5.3 Zero reset of the alarm recordings p22
4.1 - Communication with the appliance p7 5.4 Quick programming of the alarm setpoints p22
4.2 – Orientation through the programming p7 5.5 Menu adjustment (display calibration) p23
4.3 – Main menu p8 5.6 Menu Tare p24
4.4 – Programming menu p9 5.7 Setting of the brightness of the displays p24
4.4.1 – Programming of the input p9
a / Process signals p9
b / Temperature signals p10
c / Resistive sensors p10
4.4.2 – Programming of the display factor p11
4.4.3 - Programming of the advanced functions p12
4.4.4 – Programming of the analogue output p13
4.4.5 – Programming of the relay outputs p14
4.4.6 – Programming of the RS485 output p16
4.4.7 – Programming of the logic inputs p16
4.4.8 – Programming of the safeties p17
4.4.9 – Programming of the brightness and the leds p18
4.4.10 - Menu save p19
4.5 Programming of the access code p19
4.6 Menu simulation p20
4.7 Menu direct functions p20
4.8 Setting of the keyboard sensitiveness p20
4.9 Menu ABOUT (information about the product) p21
6 . ERROR MESSAGES p25
7 . GENERAL WARRANTY TERMS p25
8 . ANNEXE: MODBUS p26
To Next Page
Loading...
