35
7
MISFEED REMOVAL
When the misfeed ( ) indicator blinks or blinks in the display, the unit will
stop because of a misfeed. If a misfeed occurs when using the SPF, a number may
appear in the display after a minus sign. This indicates the number of the originals
that must be returned to the original feeder tray after a misfeed. Return the required
number of originals. Then this number will disappear when copying is resumed or the
clear ( ) key is pressed. When the SPF misfeeds an original sheet, the unit will
stop and the SPF misfeed ( ) indicator will blink, while the misfeed ( ) indicator
will remain off. For a misfeed of originals in the SPF, see "D: Misfeed in the SPF (AL-
1225)" (p.38).
1
Open the multi-bypass tray (AL-1225), and side cover, in that
order.
To open the multi-bypass tray, see "The multi-bypass tray (AL-1225)"
(p.17). To open the side cover, see "INSTALLING THE TD CARTRIDGE"
(p.10).
2
Check the misfeed location. Remove the misfed paper
following the instructions for each location in the illustration
below. If blinks in the display, proceed to "A: Misfeed in
the paper feed area" (p.36).
If the unit is turned on with the lower side cover open, the misfeed ( )
indicator will blink. In this case, close the lower side cover. The misfeed
( ) indicator will go out.
If paper is misfed here, proceed to "A:
Misfeed in the paper feed area". (p.36)
If paper is misfed here, proceed to "B:
Misfeed in the fusing area". (p.36)
If the misfed paper is seen from
this side, proceed to "C: Misfeed
in the transport area". (p.37)
To Next Page
Loading...
