7
2
Follow the installation procedure below to use the unit properly.
SETUP PROCEDURE
When using the unit for the first time, setup the unit following the procedure shown
below.
*
1
The multi-bypass tray is only included with the AL-1225.
If the unit does not function properly during setup or use, or if a function
cannot be used, see "TROUBLESHOOTING THE UNIT" (p.33).
1 Open the package, and make sure that all the accessories are
supplied with the unit. (p.8)
2 Remove the protective materials. (p.9)
3 Install the TD cartridge. (p.10)
4 Load the paper in the paper tray (p.15) or the multi-bypass
tray*
1
.
(p.17)
5 Connect the power cord and t
urn on the unit. (p.12)
6
Now, you can copy your document. (p.19)
2
SETTING UP THE UNIT
To Next Page
Loading...
Need help?
General
