EasyManuals Logo

Sharp Aquos R3 User Manual

Sharp Aquos R3
175 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
67
Call
Entering touch-tone signals
When using services in which you are required to enter
numbers additionally during a call, such as inquiry about the
balance in your bank account or ticket reservation, enter
pause (,)/wait (;) after entering a phone number to make a call
with an additional number added to the main phone number.
1
In the home screen, display “app list screen
[Phone][ ]
2
Enter a phone number[ ][Add 2-sec
pause]
3
Enter a number to send[ ]
Add wait
After making a call to a main phone number, the handset
automatically waits and then a screen asking whether to send an
additional number is displayed. Touch [YES] to send an additional
number.
1
In the home screen, display “app list screen
[Phone][ ]
2
Enter a phone number[ ][Add wait]
3
Enter a number to send[ ]
4
[YES] during the call
Emergency call
z
The handset supports “Emergency call location notification.
When you make a call to an emergency number such as 112
and 999, the information of your location (location information)
is automatically notified to the agency that has received the
emergency call (e.g. the police station). Depending on your
location and the reception status of the signal, the agency that
has received the emergency call may not be able to confirm the
exact location.
If you are not sending your caller ID by calling with “#31#”
added or other means, your location information and phone
number are not notified. However, if the agency that has
received the emergency call considers the exact location
information measured via GPS and phone number necessary
for important purposes, such as life saving, the agency may
retrieve them regardless of your settings.
In addition, the area/timing to introduce “Emergency call
location notification” depends on the state of preparation in
each agency that receives emergency calls.
z
When making an emergency call from your handset, the police
or fire stations may return your call for verification purposes.
Remain stationary to ensure that the call is not disconnected
while you are on the line, and keep the handset turned on to
receive calls for approximately 10 minutes afterwards.
z
Depending on the region, calls to the police or fire station of the
local area may not be made.
z
Emergency call may not be available in some networks.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sharp Aquos R3 and is the answer not in the manual?

Sharp Aquos R3 Specifications

General IconGeneral
Panel typeIGZO
Screen shapeFlat
Pixel density554 ppi
Display diagonal6.2 \
Touch technologyMulti-touch
Touchscreen typeCapacitive
Display resolution3120 x 1440 pixels
Maximum refresh rate120 Hz
Fingerprint resistantYes
Gorilla Glass versionGorilla Glass 5
Display number of colors16 million colors
High Dynamic Range (HDR) technologyHigh Dynamic Range 10+ (HDR10 Plus)
Processor cores1
Processor familyQualcomm Snapdragon
Coprocessor cores4
Processor frequency2.84 GHz
Coprocessor frequency1.8 GHz
Processor lithography7 nm
Processor architectureARM Cortex-A76
RAM typeLPDDR4X
RAM capacity6 GB
RAM clock speed1866 MHz
Compatible memory cardsMicroSD (TransFlash), MicroSDHC, MicroSDXC
Maximum memory card size512 GB
Internal storage capacity128 GB
Flash typeLED
Sensor typeBSI CMOS
ISO sensitivity100, 125, 160, 200, 250, 320, 400, 500, 640, 800, 1000, 1250, 1600, 2000, 2200, 2250, 2500, 3200
Rear camera typeDual camera
Front camera typeSingle camera
Maximum frame rate30 fps
Video recording modes1080p
Rear camera resolution4608 x 3456 pixels
Rear camera aperture number2.4
Second rear camera pixel size1.4 µm
Rear camera resolution (numeric)20 MP
Front camera resolution (numeric)16 MP
Second rear camera aperture number1.7
Rear camera field of view (FOV) angle78 °
Second rear camera resolution (numeric)12 MP
4G standardLTE-TDD & LTE-FDD
2G standardsEDGE, GPRS, GSM
3G standardsHSPA+, UMTS
SIM card typeNanoSIM
Wi-Fi standards802.11a, 802.11b, 802.11g, Wi-Fi 4 (802.11n), Wi-Fi 5 (802.11ac)
Bluetooth version5.0
3G bands supported800, 850, 2100 MHz
4G bands supported700, 800, 850, 900, 1700, 1800, 2100, 2300, 2500, 2600 MHz
Bluetooth profilesA2DP, AVRCP, DUN, FTP, HID, HOGP, HSP, OPP, PAN, PBAP, SPP
SIM card capabilityHybrid Dual SIM
2G bands (primary SIM)850, 900, 1900 MHz
2G bands (secondary SIM)850, 900, 1800, 1900 MHz
Mobile network generation4G
Graphics cardAdreno 640
Personal info management (PIM)Alarm clock, Calculator, Calendar, File manager
USB version3.2 Gen 1 (3.1 Gen 1)
USB connector typeUSB Type-C
Headphone connectivity3.5 mm
Form factorBar
Product colorBlack
International Protection (IP) codeIPX5, IPX8
Multimedia Messaging Service (MMS)Multimedia Messaging Service (MMS) is a standard way to send messages that include multimedia content to and from a mobile phone over a cellular network
FM radioNo
Audio systemDolby Atmos
Supported video modes240p, 360p, 480i, 480p, 525i, 540p, 576i, 576p, 625i, 720i, 720p, 768p, 960p, 1024p, 1035i, 1080i, 1080p
Audio formats supportedAAC, AAC+, AMR, AMR-NB, AMR-WB, FLAC, MIDI, MP3, OGA, OGG, OPUS, WAV, WMA
Video formats supported3GP, AVI, DIVX, FLV, H.263, H.264, H.265, MKV, MOV, MP4, VP9, WEBM, WMV, XVID
PlatformAndroid
App distribution platformGoogle Play
Operating system installedAndroid 9.0
Talk time (2G)14.5 h
Talk time (3G)30 h
Battery capacity3200 mAh
Standby time (2G)580 h
Standby time (3G)685 h
Standby time (4G)600 h
Weight and Dimensions IconWeight and Dimensions
Depth8.9 mm
Width156 mm
Height74 mm
Weight185 g

Related product manuals