Sharp AR-5420

20
2
Press and hold down the exposure mode
selector key for approximately 5 seconds.
The MANUAL ( ) indicator will go out
and the PHOTO ( ) indicator will begin
to blink. The light and dark indicator
marked "5" will light up, indicating the
standard toner mode is active.
3
To enter the toner save mode, press the
light ( ) key. The light and dark
indicator marked "1" will light up,
indicating the toner save mode is
selected.
4
4
Press the exposure mode selector key. The PHOTO ( )
indicator will stop blinking and will light up steadily. The light
and dark indicator marked "3" will light up. The toner save
mode is now active.
USER PROGRAMS
The user programs allow the parameters of certain functions to be set, changed, or
cancelled as desired.
Setting the user programs
1
Press and hold down the light ( ) key for more than 5
seconds until all the alarm indicators ( , , , ) blink
and " " appears in the display.
2
Use the left copy quantity ( ) key to select a user program
number. The selected number will blink in the left side of the
display.
3
Press the start ( ) key. The entered program number will be
steadily lit and the currently selected parameter number for the
program will blink on the right side of the display.
4
Select the desired parameter using the right copy quantity ( )
key. The entered parameter number will blink on the right of the
display.
5
To return to the standard mode, repeat the procedure but use the dark
( ) key to select exposure level "5" in step 3.