Sharp AR-5420 - Displaying Total Copy Count; Displaying Total Number of Copies

21
4
* Factory default settings are indicated with an asterisk (*).
5
Press the start ( ) key. The right-hand number in the display
will be steadily lit and the entered value will be stored.
6
Press the light ( ) to return to the normal copy mode.
DISPLAYING TOTAL NUMBER OF COPIES
Use the following procedure to display the total number of copies.
Press and hold down the clear ( ) key for approximately 5 seconds. The
total number of copies will appear in two steps, each with three digits.
Example: Total number of copies is 1,234.
Program
No.
Mode Parameters
1 Auto clear time
1 10 sec., 2 30 sec., *3 60 sec.,
4 90 sec., 5 120 sec., 6 OFF
2 Preheat mode
*1 30 sec., 2 60 sec., 3 5 min.,
4 30 min., 5 60 min., 6 120 min.,
7 240 min.
3
Auto power shut- off
mode
*1 ON, 2 OFF
4
Auto power shut- off
timer
*1 5 min., 2 30min., 3 60 min.,
4 120 min., 5 240 min.
10
Resolution of AUTO
& MANUAL mode
*1 300dpi, 2 600dpi
21 Reset factory 1 YES, *2 NO
25
Copy effective paper
width setting function
(Bypass tray)
*1 Large (A4 width),
2 Small (B5R width)
26
Copy effective paper
width setting function
(Tray 1)
*1 Large (A4 width),
2 Small (B5R width)
28
Selection of copy
start state (Polygon
rotation on/off)
*1 ON, 2 OFF
29
Fusing temperature
setting when the
bypass tray is used
1 Low, *2 High
To change the setting or to set another mode, press the clear
( ) key. The unit will return to step 2.